Anchor Pads

Description

Anchor Pads — Stop Mats from Sliding

Mats that slide, bunch, or curl create trip hazards and look unprofessional. Anchor Pads solve the problem with a simple peel-and-stick solution that keeps mats firmly in place on hard floor surfaces.

The dual-adhesive design works in two directions: one side bonds permanently to your mat backing, while the other side uses a releasable adhesive that grips the floor without leaving sticky residue when removed or repositioned.

How Anchor Pads Work

Mat Side (Permanent): Strong adhesive bonds directly to the mat’s rubber or vinyl backing. This side stays attached to the mat.

Floor Side (Releasable): Repositionable adhesive grips hard floor surfaces firmly during use but releases cleanly when you need to move the mat. No sticky residue left behind.

This dual-adhesive approach means you can reposition mats as needed without replacing the pads or damaging your floors.

Product Specifications

How Many Pads Per Mat?

General rule: One pad on each corner. Add pads along edges for larger mats or high-traffic areas.

Compatible Floor Surfaces

Recommended:

• Sealed concrete
• Ceramic and porcelain tile
• Hardwood (finished/sealed)
• Laminate
• Vinyl/LVT
• Terrazzo
• Polished stone

Not Recommended:

• Carpet (use cleated backing instead)
• Unsealed/porous concrete
• Unfinished wood
• Outdoor surfaces exposed to moisture

Compatible Mat Types

Works Well With:

• Entrance mats with solid rubber backing
• Anti-fatigue mats
• Modular tiles (sold separately from pre-attached versions)
• Logo mats
• Carpeted mats with solid backing

Not Recommended For:

• Drain-through mats (holes in backing prevent adhesion)
• Mats with cleated backing (designed for carpet, not hard floors)

Pre-Attached Anchor Pads

Some modular tile products come with Anchor Pads already attached:

Hog Heaven III Modular Tiles:

• 18″ tiles include 1 Anchor Pad (pre-attached)
• 36″ tiles include 4 Anchor Pads (pre-attached)

If your tiles already have pads attached, you don’t need to purchase additional pads unless replacing worn ones.

Installation Instructions

1. Clean the floor — Remove dust, dirt, and debris from the area where the mat will be placed. The adhesive bonds best to clean, dry surfaces.
2. Clean the mat backing — Wipe the underside of the mat to remove any dust or residue.
3. Position the pads — Peel the backing from the permanent (mat) side of each pad. Press firmly onto the mat backing at each corner.
4. Place the mat — Position the mat where you want it. Once positioned, peel the backing from the floor side of each pad.
5. Press down firmly — Apply pressure to the mat edges and corners to ensure good contact between the pads and floor.

Repositioning or Removal

To move a mat with Anchor Pads installed:

1. Lift the mat slowly from one corner.
2. The releasable adhesive will release from the floor while remaining attached to the mat.
3. Reposition the mat and press down to re-engage the adhesive.

The releasable adhesive can typically be repositioned multiple times before losing grip. If pads no longer hold firmly, replace with fresh pads.

Frequently Asked Questions

How many Anchor Pads do I need?
Place one pad on each corner as a minimum. For mats larger than 3′ x 5′, add pads along the edges. See the sizing chart above.

Will Anchor Pads damage my hardwood floors?
No. The floor-side adhesive is designed to release cleanly without leaving residue. However, we recommend testing on an inconspicuous area first, especially on antique or delicate finishes.

Can I reposition mats after installing the pads?
Yes. The releasable floor-side adhesive allows you to lift and reposition mats. The pads stay attached to the mat and re-grip when pressed down again.

Do these work on carpet?
No. Anchor Pads are designed for hard floor surfaces only. For carpet, use mats with cleated rubber backing instead.

How long do Anchor Pads last?
Pads remain effective for years under normal use. Replace if the adhesive no longer grips firmly or if the pad becomes damaged.

Can I use these with drain-through mats?
No. Drain-through mats have holes in the backing that prevent proper adhesion. Anchor Pads work best with solid-backed mats.

What’s the difference between Anchor Pads and Double-Sided Tape?
Anchor Pads are repositionable and designed for lighter-duty applications (entrance mats, anti-fatigue mats). Double-Sided Tape provides a stronger, more permanent bond and is required for heavy applications like WaterHog Forklift mats under wheeled traffic.

Do I need pads for large mats?
Mats larger than 4′ x 8′ usually stay in place due to their own weight. Anchor Pads are most useful for smaller, lighter mats that tend to slide or bunch.

Additional information