Corrugated Switchboard
24" x 75'
36" x 75'
48" x 75'
Diamond Plate Switchboard
36" x 75'
Military Diamond Switchboard
36" x 75'
Military S
Corrugated & Diamond Plate Switchboard Matting
SURFACE
Material: PVC (vinyl)
Thickness: 1/4 inch (0.25")
STANDARDS & TESTING
Passes electrical proof test ASTM D178 (Min. 20,000 V for one minute)
Passes dielectric breakdown test ASTM D149 (Min. 30,000 V)
Passes O3 resistance test method B ASTM D178 (any visual degradation)
Tensile strength ASTM D412 DIE C (Minimum 700 PSI): 1,318 PSI, PASS
Elongation ASTM D412 DIE C (Minimum 250%): 317%, PASS
Tension set ASTM D412 DIE B (Maximum 0.50 in.): 0.4827 in., PASS
Moisture absorption ASTM D570 (Maximum increase 3%): 0.09%, PASS
Accelerated aging ASTM D573 (Minimum 50% of original tensile strength): 1,363 PSI (103% of original tensile strength), PASS
Flame resistance ASTM D178 Appendix (Maximum 0.5 in./12.7mm after 30 seconds): 0.12 mm/s, PASS
Oil resistance ASTM D471 (Maximum volume increase 4%): 0.04%, PASS
Military Diamond Switchboard Matting
SURFACE
Material: PVC (vinyl)
Thickness: 3/16 inch (0.1875")
STANDARDS & TESTING
Voltage Test MIL-DTL-15562G, Min. 15,000V for 1 Minute, Pass
Dielectric Strength Test MIL-DTL-15562G, Min. 30,000V, Pass
Visual/Dimensional Exam MIL-STD-407, Any Visual Degradation, Pass
Tensile Strength ASTM D412 DIE C, Min. 800PSI, Pass
Ultimate Elongation ASTM D412 DIE C, Min. 75%, Pass
Permanent Set ASTM D412, Max. 25%, Pass
Hardness ASTM D2440, 95+/-5(Shore A), Pass
Immersion Test FED-STD-601 Method 6121, Min. 70% of Original Tensile Strength, Pass
Oxygen Bomb Test FED-STD-601 Method 7111, Min. 80% of Original Tensile Strength, Pass
Light Aging ASTM D750, Min. 65% of Original Tensile Strength, Pass
Flame Resistance MIL-STD-1623, Char Length Max. 10in. Combustion Time 4.0 Min, Pass
Abrasion Resistance ASTM D1242, Max. Mils Lost 10, Pass
Flexibility Test FED-STD-501 Method 3111 Shall Pass, Pass
Dimensional Stability Test ASTM D1204, +/-0.020 IN/FT, Pass
Gloss Test ASTM D2457, 50, Pass
Color FED-STD-595, As Specified, Pass
Military Smooth Switchboard Matting
SURFACE
Material: PVC (vinyl)
Thickness: 1/8 inch (0.125")
Switchboard mats can be cleaned using the instructions below:
Scrubbing with a deck brush (when needed)
Using detergent with a neutral pH
Rinsing with a hose or pressure washer
Mat should be laid flat or hung to dry
Always make sure the mat is dry before placing it back in service.
