Switchboard (Non-Conductive) Matting

Corrugated Switchboard
24" x 75'
36" x 75'
48" x 75'

Diamond Plate Switchboard
36" x 75'

Military Diamond Switchboard
36" x 75'

Military S

Corrugated & Diamond Plate Switchboard Matting

SURFACE

Material: PVC (vinyl)
Thickness: 1/4 inch (0.25")

STANDARDS & TESTING

• Passes electrical proof test ASTM D178 (Min. 20,000 V for one minute)

• Passes dielectric breakdown test ASTM D149 (Min. 30,000 V)

• Passes O3 resistance test method B ASTM D178 (any visual degradation)

• Tensile strength ASTM D412 DIE C (Minimum 700 PSI): 1,318 PSI, PASS

• Elongation ASTM D412 DIE C (Minimum 250%): 317%, PASS

• Tension set ASTM D412 DIE B (Maximum 0.50 in.): 0.4827 in., PASS

• Moisture absorption ASTM D570 (Maximum increase 3%): 0.09%, PASS

• Accelerated aging ASTM D573 (Minimum 50% of original tensile strength): 1,363 PSI (103% of original tensile strength), PASS

• Flame resistance ASTM D178 Appendix (Maximum 0.5 in./12.7mm after 30 seconds): 0.12 mm/s, PASS

• Oil resistance ASTM D471 (Maximum volume increase 4%): 0.04%, PASS

Military Diamond Switchboard Matting

SURFACE

Material: PVC (vinyl)
Thickness: 3/16 inch (0.1875")

STANDARDS & TESTING

• Voltage Test MIL-DTL-15562G, Min. 15,000V for 1 Minute, Pass

• Dielectric Strength Test MIL-DTL-15562G, Min. 30,000V, Pass

• Visual/Dimensional Exam MIL-STD-407, Any Visual Degradation, Pass

• Tensile Strength ASTM D412 DIE C, Min. 800PSI, Pass

• Ultimate Elongation ASTM D412 DIE C, Min. 75%, Pass

• Permanent Set ASTM D412, Max. 25%, Pass

• Hardness ASTM D2440, 95+/-5(Shore A), Pass

• Immersion Test FED-STD-601 Method 6121, Min. 70% of Original Tensile Strength, Pass

• Oxygen Bomb Test FED-STD-601 Method 7111, Min. 80% of Original Tensile Strength, Pass

• Light Aging ASTM D750, Min. 65% of Original Tensile Strength, Pass

• Flame Resistance MIL-STD-1623, Char Length Max. 10in. Combustion Time 4.0 Min, Pass

• Abrasion Resistance ASTM D1242, Max. Mils Lost 10, Pass

• Flexibility Test FED-STD-501 Method 3111 Shall Pass, Pass

• Dimensional Stability Test ASTM D1204, +/-0.020 IN/FT, Pass

• Gloss Test ASTM D2457, 50, Pass

• Color FED-STD-595, As Specified, Pass

Military Smooth Switchboard Matting

SURFACE

Material: PVC (vinyl)
Thickness: 1/8 inch (0.125")

Switchboard mats can be cleaned using the instructions below:

• Scrubbing with a deck brush (when needed)

• Using detergent with a neutral pH

• Rinsing with a hose or pressure washer

• Mat should be laid flat or hung to dry

Always make sure the mat is dry before placing it back in service.