Recommended for use in large commercial entryways, especially in the retail and hospitality industries. The tight weave of Berber makes it resistant to damage from golf shoes and ideal for use in clubs and other locations where spiked footwear may be worn by guests or employees.
6' x 125' roll
12' x 125' roll
Custom sizes are available in the following widths up to 50' in length. Please note that widths over 6' may be seamed based on material availability.
3' widths
4' widths
5' widths
6' widths
7' widths
8' widths
9' widths
10' widths
11' widths
12' widths
The width must be in one of the whole foot increments listed above.
Available with smooth backing only.
Please note, mat sizes are approximate as rubber shrinks and expands in conjunction with temperature and time. Tolerable manufacturing size variance is 3-5%.
SURFACE
Material: Solution-dyed polypropylene
Weight: 52 ounces/yard2
Construction: Needle-punched
Design: Hobnail
BACKING
Material: Performance rubber
Overall Mat Thickness: 3/8 inch (0.375")
STANDARDS & TESTING
Passes DOC-FF1-70 for the surface flammability for the surface of carpets
Berber Roll Good mats can be cleaned using the instructions below:
Vacuum regularly (daily in high-traffic commercial areas; weekly in lower traffic areas)
Extract or hose off as needed to remove heavy soil/debris
Hang mat to dry
Always make sure the mat is dry before placing it back in service.
Measure
Determine the number of square feet that you will need. Measure the length and width of the area you wish to cover. Multiply the width by the length to get the square footage of the space. For areas that are not rectangular, break the area into smaller rectangles. Multiply the width times the length for each of the smaller rectangles separately, and add up all the results to arrive at the overall square footage.
Prepare
Remove any old floor coverings, debris, and adhesives from the floor. Clean the entire floor surface of any dust, drywall mud, etc. Once the floor has been cleaned, allow it to dry completely. Allow the matting material to sit in the area uninstalled for several hours so it can acclimate to room temperature prior to installation.
Install
Apply your adhesive to the prepared floor according to the adhesive manufacturer's directions. We recommend CA024 multi-purpose solvent-free adhesive for all installations both indoor and outdoor. Never use an adhesive that contains solvents. Similar to laying carpet, roll the matting out over the installation area and carefully trim the excess material around the perimeter using a utility knife.
